Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
56
Re-Initialization Procedure
Automatic operation of the sunroof must be
re-initialized in case of faulty sunroof opera-
tion. It may also be necessary to initialize the
sunroof after the vehicle’s battery has been
disconnected and then reconnected.
NOTE:
The anti-pinch safety device is deactivated
during the re-initialization procedure.
Proceed as follows:
1. With the ignition in the ON/RUN position,
make sure the sunroof glass is fully closed
(sunshade open).
2. Open the driver’s side door, and place the
ignition in the OFF position.
3. Within five seconds, place the ignition in
the ACC or ON/RUN position.
4. Within 10 seconds, push and hold the sunroof
close switch (forward). After 8 - 10 seconds of
holding the switch, the re-initialization process
will begin. Continue to hold the switch while the
sunroof motor cycles, and the sunshade will
fully close.
5. Once the sunroof glass and the power
sunshade have stopped motion, release
the sunroof close switch, then push and
hold it again within five seconds. Continue
to hold the switch while the sunshade fully
opens, the sunroof glass fully opens,
followed by the glass fully closing then the
sunshade fully closing.
6. Release the switch once the operations
stop. Re-initialization of the sunroof
motors is now complete.
NOTE:
If the switch is released prior to full completion
of the operations described, the entire
re-initialization procedure must be repeated
from step 1.
7. Confirm express operations for the
sunroof glass and sunshade is functional
for opening and closing operations.
HOOD
Opening
To open the hood, proceed as follows:
1. Pull the release lever located on the
driver’s side kick panel.
Hood Release Lever
2. Go to the outside of the vehicle and posi-
tion yourself in front of the grille.
3. Lift the hood slightly.
20_GA_OM_EN_USC_t.book Page 56
Loading ...
Loading ...
Loading ...