Loading ...
Loading ...
Loading ...
STARTING AND OPERATING
200
Exiting A Lane With Detection Of A Single Limit
When the system is active and only, for
example, the left lane limit has been detected,
the detected lane illuminates in white on the
display; the system is ready to provide visual
warnings on the display in the event of unin-
tentional exiting of the lane (turn signal not
activated) to the left.
Left Lane Limit Detected
When the system detects that the vehicle has
approached the lane line and is about to pass it,
the left line on the display illuminates in yellow.
Left Lane Limit Approached
The system operates in the same way, but
mirrored, in the event of exiting the right lane
when only the right lane limit has been
detected.
Exiting A Lane With Detection Of Both Limits
When the system is active, both lane lines on
the display illuminate in white to indicate the
successful detection of both limits.
When lane limits are detected, the system is
ready to provide indications in case the driver
unintentionally leaves the lane (turn signal not
activated).
As the Lane Departure Warning system
detects the lane limits while the vehicle is in
motion, it will adjust the display accordingly
(from white to yellow and vice versa, and
increase their thickness).
If a line is crossed, the driver is alerted by an
audible signal as well as the visual indication
in the instrument cluster. The signal is emitted
through the speakers on the side of the lane
limit which is being crossed (e.g. if the vehicle
is exceeding the left line of the lane, the
audible signal will come from the speakers on
the left of the vehicle).
Changing The System Settings
The system's sensitivity can be set through the
radio system. Sensitivity “High” or “Low” can
be selected.
To access the function, from the main menu
select the following in order:
1. “Settings”
2. “Comfort”
3. “Lane Departure Warning”
4. “Sensitivity”
Limited Operation Warning
If a message appears on the display, a condi-
tion limiting the Lane Departure Warning
system operation may have occurred. This
could be an obstruction of the camera view, or
a fault in the system.
If an obstruction is detected, clean the area of
the windshield by the interior rear view mirror.
Although the vehicle can still be driven in
normal conditions, the system may not func-
tion properly.
When the conditions limiting the system are
corrected, it will go back to normal operation.
Should a fault persist, contact an authorized
dealer.
System Failure Warning
If the system turns off and the warning light
appears on the display, it means that there is
a system fault.
In this case, it is still possible to drive the
vehicle, but you are advised to contact an
authorized dealer as soon as possible.
20_GA_OM_EN_USC_t.book Page 200
Loading ...
Loading ...
Loading ...