Loading ...
Loading ...
Loading ...
Mavic Air
2
User Manual
44
©
2020 DJI All Rights Reserved.
Auto Takeoff/Landing
Auto Takeo
Use auto takeo when the aircraft status indicator blinks green.
1. Launch DJI Fly and enter the camera view.
2. Complete all steps in the pre-ight checklist.
3. Tap . If conditions are safe for takeo, press and hold the button to conrm.
4. The aircraft will take o and hover 3.9 ft (1.2 m) above the ground.
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom inner or
outer corners to start the motors. Once the motors have started spinning, release both sticks simultaneously.
Stopping the Motors
There are two methods to stop the motors.
1. Method 1: When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.
2. Method 2: When aircraft has landed, push the left stick down, then conduct the same CSC that was used
to start the motors, as described above. The motors will stop immediately. Release both sticks
once the motors have stopped.
The aircraft status indicator indicates whether the aircraft is using GPS and/or the Downward
Vision System for flight control. It is recommended to wait until the GPS signal is strong before
using auto takeoff.
DO NOT takeoff from an moving surface, such as a moving boat or vehicle.
OR
Auto Landing
Use auto landing when the aircraft status indicator blinks green.
1. Tap . If conditions are safe to land, press and hold the button to conrm.
2. Auto landing can be cancelled by tapping .
3. If the Vision System is working normally, Landing Protection will be enabled.
4. Motors stops after landing.
Choose an appropriate place for landing.
Loading ...
Loading ...
Loading ...