Loading ...
Loading ...
Loading ...
©
2020 DJI All Rights Reserved.
31
Remote Controller
Remote Controller Profile
Built into the remote controller is DJI’s long-range transmission technology OcuSync 2.0, oering a maximum
transmission range of 6 mi (10 km) and displaying video from the aircraft to DJI Fly on your mobile device at up
to 1080p. Control the aircraft and camera smoothly using the onboard buttons while the detachable control
sticks make the remote controller easy to store.
In a wide-open area with no electromagnetic interference, OcuSync 2.0 smoothly transmits video links at up to
1080p, no matter how the ight attitude is changed. The remote controller works at both 2.4 GHz and 5.8 GHz,
automatically selecting the best transmission channel.
OcuSync 2.0 reduces the latency to 120-130 ms by improving the camera performance through its video
decoding algorithm and the wireless link.
The built-in battery has a capacity of 5200 mAh and a maximum run time of 6 hours. The remote controller
charges the mobile device with a charging ability of 500 mA@5V. The remote controller automatically charges
Android devices. For iOS devices, rst make sure that charging is enabled in DJI Fly. Charging for iOS devices
is disabled by default and needs to be enabled each time the remote controller is powered on.
Compliance Version: The remote controller is compliant with local regulations.
Control Stick Mode: The control stick mode determines the function of each control stick movement.
Three pre-programmed modes (Mode 1, Mode 2, and Mode 3) are available and custom modes can be
congured in DJI Fly. The default mode is Mode 2.
Using the Remote Controller
Powering On/O
Press the power button once to check the current battery level. Press once, then again, and hold to power the
remote controller on or o. If the battery level is too low, recharge before use.
Controlling the Gimbal and Camera
1. Shutter/Record Button: Press once take a photo
or to start or stop recording.
2. Photo/Video Toggle: Press once to switch
between photo and video mode.
3. Gimbal Dial: Use to control the tilt of the gimbal.
Charging the Battery
Use a USB-C cable to connect an AC power charger to the USB-C port of the remote controller. It takes
approximately four hours to fully charge the remote controller.
Gimbal Dial
Shutter/Record
Button
Photo/Video
Toggle
Power Outlet
Loading ...
Loading ...
Loading ...