Loading ...
Loading ...
Loading ...
50 GETTING TO KNOW YOUR VEHICLE
5. Push and hold the programmed
HomeLink® button and observe the
indicator light.
If the indicator light stays on constantly,
programming is complete and the
garage door/device should activate
when the HomeLink® button is pushed.
To program the two remaining Home-
Link® buttons, repeat each step for
each remaining button. DO NOT erase
the channels.
Canadian/Gate Operator Programming
For programming transmitters in Canada/
United States that require the transmitter
signals to “time-out” after several seconds of
transmission:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink® to pick up the signal
during programming. Similar to this Canadian
law, some US gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the
cycling process to prevent possible overheating
of the garage door or gate motor.
1. Place the ignition in the MAR (ACC/ON/
RUN) position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the Home-
Link® button you wish to program while
keeping the HomeLink® indicator light in
view.
3. Continue to push and hold the HomeLink®
button while you push and release (cycle)
your hand-held transmitter every two
seconds until HomeLink® has successfully
accepted the frequency signal. The indi-
cator light will flash slowly and then rapidly
when fully trained.
4. Watch for the HomeLink® indicator to
change flash rates. When it changes, it is
programmed. It may take up to 30 seconds
or longer in rare cases. The garage door
may open and close while you are program-
ming.
5. Push and hold the programmed
HomeLink® button and observe the
indicator light.
NOTE:
If the indicator light stays on constantly,
programming is complete and the
garage door/device should activate
when the HomeLink® button is pushed.
To program the two remaining
HomeLink® buttons, repeat each
st
ep for each remaining button. DO
NOT erase the channels.
If
you unplugged the garage door opener/device
for programming, plug it back in at this time.
Using HomeLink®
To operate, switch the ignition to the MAR
(ACC/ON/RUN) position and the press and
release the programmed HomeLink® button.
Activation will now occur for the programmed
device (i.e., garage door opener, gate oper-
ator, security system, entry door lock, home/
office lighting, etc.,). The hand-held trans-
mitter of the device may also be used at any
time. If the ignition is placed in the STOP
(OFF/LOCK) position, HomeLink® will remain
active for three minutes. During this time, if
the vehicle is locked, HomeLink® is disabled.
20_BG_OM_EN_US_t.book Page 50
Loading ...
Loading ...
Loading ...