Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 49
1. Place the ignition in the MAR (ACC/ON/RUN)
position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the Home-
Link® button you wish to program while
keeping the HomeLink® indicator light in
view.
3. Push and hold the HomeLink® button you
want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe
the indicator light. The HomeLink® indi-
cator will flash slowly and then rapidly after
HomeLink® has received the frequency
signal from the hand-held transmitter.
Release both buttons after the indicator
light changes from slow to rapid.
5. At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAINING”
button. This can usually be found where
the hanging antenna wire is attached to
the garage door opener/device motor.
Firmly push and release the “LEARN” or
“TRAINING” button. On some garage door
openers/devices there may be a light that
blinks when the garage door opener/
device is in the LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the next
step after the LEARN button has been pushed.
6. Return to the vehicle and push the
programmed HomeLink® button twice
(holding the button for two seconds each
time). If the garage door opener/device
activates, programming is complete.
NOTE:
If the garage door opener/device does not acti-
vate, push the button a third time (for two
seconds) to complete the training.
To program the remaining two HomeLink®
buttons, repeat each step for each remaining
button. DO NOT erase the channels.
Programming A Non-Rolling Code
For programming garage door openers manu-
factured before 1995:
1. Place the ignition in the MAR (ACC/ON/
RUN) position.
2. Place the hand-held transmitter 1 to
3 inches (3 to 8 cm) away from the Home-
Link® button you wish to program while
keeping the HomeLink® indicator light in
view.
3. Push and hold the Homelink® button you
want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe
the indicator light. The HomeLink® indi-
cator will flash slowly and then rapidly after
HomeLink® has received the frequency
signal from the hand-held transmitter.
Release both buttons after the indicator
light changes from slow to rapid.
2
20_BG_OM_EN_US_t.book Page 49
Loading ...
Loading ...
Loading ...