User Manual - Page 11

For 2020 FIAT 500L.

Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 9
To replace the battery, proceed as follows:
1. Push the mechanical release button to
open the mechanical key.
2. Turn the screw to unlock using a small
screwdriver.
3. Take out the battery case and replace the
battery making sure that polarities are
correct.
4. Replace the battery case inside the key
and lock it by turning the screw to lock.
NOTE:
Used batteries should be properly disposed of as
specified by law; see an authorized dealer for
assistance needed.
Programming Additional Key Fobs
Refer to “Sentry Key” in this chapter for further
information.
If you do not have a programmed key fob,
contact an authorized dealer for details.
Request For Additional Remote Controls
The system can recognize up to eight remote
controls. Should a new remote control be
necessary, go to an authorized dealer. Bring an
ID document and the vehicle ownership docu-
ments with you.
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and
Economic Development Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic Develop-
ment applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes:
1. l'appareil ne doit pas produire de brouil-
lage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en comprom-
ettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no
cause interferencia perjudicial y
2. este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user’s authority to operate
the equipment.
2
20_BG_OM_EN_US_t.book Page 9
Loading ...
Loading ...
Loading ...