Loading ...
Loading ...
Loading ...
22 GETTING TO KNOW YOUR VEHICLE
Rear Head Restraint Removal
To remove the outboard or center head
restraints, raise it as far as it can go. Then, push
the adjustment button and the release button
at the base of each post while pulling the head
restraint up. To reinstall the head restraint, put
the head restraint posts into the holes and push
downward. Then, adjust it to the appropriate
height.
STEERING WHEEL
Tilt/Telescoping Steering Column
This feature allows you to tilt the steering
column upward or downward. It also allows you
to lengthen or shorten the steering column. The
tilt/telescoping control handle is located on the
steering column, below the turn signal lever.
Tilt/Telescoping Control Handle
To unlock the steering column, pull the control
handle down. To tilt the steering column, move
the steering wheel upward or downward as
desired. To lengthen or shorten the steering
column, pull the steering wheel outward or push
it inward as desired. To lock the steering column
in position, push the control handle up until fully
engaged.
WARNING!
A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head
restraints in a location outside the occupant
compartment.
ALL the head restraints MUST be reinstalled
in the vehicle to properly protect the occu-
pants. Follow the re-installation instructions
above prior to operating the vehicle or occu-
pying a seat.
WARNING!
Do not adjust the steering column while
driving. Adjusting the steering column while
driving or driving with the steering column
unlocked, could cause the driver to lose
control of the vehicle. Failure to follow this
warning may result in serious injury or death.
20_BG_OM_EN_US_t.book Page 22
Loading ...
Loading ...
Loading ...