Hikvision DS-K1T690MW Quick Start Guide

Loading ...

Press Key to Enter Card Number

If you enable this funcon, you can input the card No. by pressing the key.

Wi-Fi Probe

If you enable this funcon, the device can probe the surrounding communicaon devices'

MAC address and upload the MAC address to the system. If the MAC address match the

specied MAC address, the system can trigger some linkage acons.

3G/4G

If you enable this funcon, the device can communicate in 3G/4G network.

NFC An-Cloning

If you enable this funcon, you cannot use the cloned card for authencaon and further

enhance security.

Click OK.

Oponal: Click Copy to, and then select the access control device(s) to copy the parameters in

the page to the selected device(s).

Congure Parameters for Door/Elevator

Aer adding the access control device, you can congure its access point (door or oor)

parameters.

Before You Start

Add access control device to the client.

Steps

Click Access Control → Advanced Funcon → Device Parameter .

Select an access control device on the le panel, and then click

to show the doors or oors of

the selected device.

Select a door or oor to show its parameters on the right page.

Edit the door or oor parameters.

Note

●

The displayed parameters may vary for dierent access control devices.

●

Some of the following parameters are not listed in the Basic Informaon page, click More to

edit the parameters.

Name

Edit the card reader name as desired.

Door Contact

You can set the door sensor as remaining closed or remaining open. Usually, it is remaining

closed.

Exit Buon Type

DS-K1T690 Series Face Recognion Terminal User Manual

145

Loading ...

Hikvision DS-K1T690MW Ultra Face Recognition Terminals