Loading ...
Loading ...
Loading ...
5.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
6.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
7.
Click Save.
10.3.3 Set Region Entrance Detecon
It is used to detect objects entering a predened virtual region from the outside place. If it occurs,
the device can take linkage acons.
Before You Start
●
Go to VCA and select any of the smart applicaons that come with the system.
Steps
1.
Go to VCA → Set Applicaon → Smart Event → Region Entrance Detecon .
2.
Check Enable.
3.
Click Add to add a rule and set a detecon area.
1) Draw a detecon area. Click , click on the live view to specify the vertexes and draw the
boundaries of the detecon area, and right click to complete drawing.
2) Set the minimum size and the maximum size for the target to improve detecon accuracy.
Only targets whose size are between the maximum size and the minimum size trigger the
detecon. Click and , then drag the mouse in the live view to draw the minimum and
maximum target size.
3) Oponal: Click to delete all the seng areas.
4.
Set parameters.
Sensivity
It stands for the percentage of the body part of an acceptable target that goes across the
predened region. Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predened region. ST stands for the complete target body. The higher the value of
sensivity is, the more easily the alarm can be triggered.
Network Camera User Manual
81
Loading ...
Loading ...
Loading ...