Loading ...
Loading ...
Loading ...
English 51
Maintenance
How to reinstall the door
1. Firmly grasp both sides of the door at the top.
At rst, reconnect the camera's wire harness at the bottom of the door.
2. With the door at the same angle as the removal position, slide the indentations
of the hinge arms into the bottom edges of the hinge slots. The notches in each
hinge arm must be fully inserted into the bottoms of each slot.
Hinge armHinge arm
Bottom edge of slotBottom edge of slot
IndentationIndentation
3. Open the door fully. If the door will not open fully, the indentations are not
inserted correctly in the bottom edges of each slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
Locked position Unlocked position
Hinge lock
5. Close the oven door.
CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward
to arrange them as they were before you removed the door. Wires that are not
connected or arranged correctly can be caught in the door or damaged by heat.
How to remove and reinstall the Storage drawer
Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Using both hands, pull down the left
clip while lifting the right clip, and then
remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4. Put the drawer in the roller guides on
either side, and then snap the clips into
place.
Loading ...
Loading ...
Loading ...