Loading ...
Loading ...
Loading ...
AXIS P3364–V
System Options
•Linkup
• Authentication failed
SNMP v3 provid es encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
HTTPS, on page 38
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lo st, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 49
.
UPnP
TM
The Axis pro duct includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are co nfig u red under System Options > Network > RTP .
The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For mu lticas t stre ams ,
only certain IP a ddresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming witho ut open ing an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjo ur is enabled by default and the produ ct is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted b efore it is ejected.
The Axis product supports SD cards with the following file systems:
• ext4 — recom m e nde d due to its resilience against data loss if the card is ejected or if there is a brupt power loss. To access
data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.
• vFAT — most SD cards are p re-formatted with vFAT when purchased.
If required, the SD card can be re-formatted to the desired file system. To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System O ptions > Storage and click SD Card.
3. Click Format and select the desired file system.
Note
During formatting any pre vious data s tored on the disk wi ll be lost.
46
Loading ...
Loading ...
Loading ...