Loading ...
Loading ...
Loading ...
What to do in an emergency
167
If you have a flat tire (with Tire Mobility Kit)
Checking the tire inflation pres
-
sure
After driving briefly so as to distribute
the sealant throughout the inside of the
tire, you should check the tire inflation
pressure.
1. After driving approximately 4~6 miles
(7~10 km or about 10 minutes), stop
at a safe location.
2. Connect the filling hose of the com
-
pressor (clip mounted side) directly
and then connect the filling hose
(opposite side) to the tire valve.
3. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
4. Adjust the tire inflation pressure to the
cold tire recommended pressure as
indicated on the vehicle's placard or
tire inflation pressure label located on
the driver's side center pillar outer
panel. (In this owner's manual, refer to
"Tires and wheels" on page 9-4.)
僅
To increase the inflation pres
-
sure
, switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
NOTICE
The pressure gauge may show higher
than actual reading when the compres
-
sor is running. To get an accurate tire
reading, the compressor needs to be
turned off.
WARNING
Do not let the compressor run for more
than 10 minutes; otherwise, the device
may overheat and be damaged.
僅
To reduce the inflation pressure
,
press the valve on the compressor.
CAUTION
Tire Pressure Sensor
When you use the Tire Mobility Kit with a
sealant that is not approved by Kia, the
tire pressure sensors may be damaged
by sealant. The sealant on the tire pres
-
sure sensor and wheel should be
removed when you replace the tire with
a new one and the tire pressure sensors
should be inspected at an authorized
dealer.
OCV061015L
Loading ...
Loading ...
Loading ...