Loading ...
Loading ...
Loading ...
Configuration
Configure Data Transfer to Printer and PC 7
7-7
Configure Interface to PC
Settings Description
RS232 Serial interface
GPIB General Purpose Interface Bus: IEEE488 interface (optional)
LAN Ethernet (LAN) interface (optional)
SCPI Standard set of commands
D5255S Previous set of commands (emulation)
D5255T Previous set of commands (emulation)
D5255M Previous set of commands (emulation)
1. Move the cursor to the field with the value you wish to change, enter the new
value and confirm by pressing Enter.
2. Select the settings and confirm by pressing Enter.
The applied settings are shown in line Syst IF.
Note
A CD to install USB driver support to the PC is included in the delivery
content. The USB interface is installed as a virtual COM port.
Configure RS 232
Settings Description
115200 ...1200 Baud rate of serial interface
8/N/1 …7/O/1 Data bits/parity/stop bits of the serial interface
none
HW
XON
Handshake (protocol) of the serial interface
Note
The factory settings of the RS232 interface are optimized for
communication with a PC. We recommend adjusting the settings of the PC
to suit these parameters.
Factory configuration: 115200 8/N/1 HW
1. On the connected PC, call up the Device Manager and open the dialog showing
the settings for the serial port.
2. Adjust these settings to those of the Power Analyzer.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...