Loading ...
Loading ...
Loading ...
1760
Users Manual
2-4
Setup
Installation
Follow the safety instructions regarding the ambient conditions and location of the
installation.
XW Warning
First connect the device with the mains cable and compatible
adapter to the power supply network. Observe the
specifications on the device type plate.
The device is connected to mains power, and a number of
internal components are live with dangerous voltage levels. To
remain safe during the operation, the device must be equipped
with a low-resistance connection to the earth. Therefore, check
the mains socket and its wiring.
Connect the supply cable of the device only to the sections
CAT I, II or III of the supply system. The voltage to earth may
not exceed 300 V.
Switching the Device On
Switch on the power supply to the device (lift switching knob B slightly and move to
position ‘I’). The LED POWER is lit. After approx. 40 seconds of booting, the device is
ready for the operation.
Switching the Device Off
Lift switching knob B slightly and move to position ‘0’. The LED POWER goes off
after closing all the internal data files.
Note
The instrument can be only switched off after the boot process is finished
(duration is approx. 40 seconds).
Simple Measurement - Function Check
The procedure below allows users to familiarize themselves with the measuring functions
of the instrument, while testing all basic device functions.
Installation: Install the instruments SW PQ Analyze, see Reference Manual PQ
Analyze.
Connect device: Connect instrument to mains and switch on.
Connect your computer and the recorder via the red Ethernet cable
for direct connection. Wait for a short time (see the 1760 Reference
Manual, “Direct Peer to Peer Communication over Crossover
Ethernet Cable”.
Connect the device channels as described in the “Connections to
Measuring Circuits”.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...