Loading ...
Loading ...
Loading ...
i iiiiiiiiiii_ii_i!_i
iiiiii%_i!iiiiiiiiiiiiiii_iii!,!i_!!i_iii
iiiiiiiiiiiiiiiiiii!!i_ii!iii!
iiiiiiiiiiiiiiiiiiiiiiiiiiiii!iiiiii;iii_iiiiiill
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii i ! ! ! ;ii
You can connect the DVD-AR650 to an external audio amplifier or a
HomeTheatersystem.
This allows you to setup the audio device and aound atatus settings
depending on the audio system in use.
1. With the unit in Stop mode/No Disc mode, press the MENU button on
the remote control.
2. Setect Setup using the A v buttons, then press the ENTER or _.
button.
3, Select Audio using the A T buttons, then press the ENTER or
button.
4. Select the sub menu(Digital Output, DTS, Dynamic Compression)
using the A T buttons, then press the ENTER or _ button.
Select the item that matches the audio connection you've selected
on pages 23-35 (Method 1, 2 and 3).
Digital Output
• PCM : Converts to PCM(2CH) 48kHz audio.
Select PCM if your amplifier system is stereo and/or Dolby Prologic.
• Bitstream : Outputs Bitstream.
Select Bitstream if your amplifier system supports multi channet digitat
audio surround decoding such as Dotby Digital and/or DTS.
DT8
• Off : Doesn't output DTS bitstream.
• On : Outputs DTS bitstream. (via Digitat Audio Output)
Select DTS when connecting to a digital amp with a DTS decoder.
• When DTS soundtrack is played, sound is not output from Analog Audio Output.
Dynamic Compression
This is only active when a Dolby Digital signal is detected.
,, Off : You can enjoy the movie with the standard Dynamic Range.
,, On : When movie soundtracks are played at low volume or from small
speakers, the system can apply appropriate compression to make low-
tevel content more intelligible and prevent dramatic passages from
getting too toud.
English - 38
Loading ...
Loading ...
Loading ...