Loading ...
Loading ...
Loading ...
35
Emptying program en-us
8. Remove the milk tube from the milk container, wipe it
down and insert the end of the milk tube into the hole
on the coffee residue container.
9. Close the door.
10. Touch the I symbol.
The program will run for approx. 19 minutes.
Note: If there is too little descaling solution in the
water tank, the message "Fill water tank with water
and descaler" appears. Fill the empty water tank with
lukewarm water up to the "calc" mark (17 oz/0.5l) and
then dissolve a descaling tablet in it. Press ™ to
confirm. The program will continue.
11. If a water filter is used, reinsert it now.
12. Touch the I symbol.
The program will run for approx. 7 minutes and rinse
the appliance.
The program has finished.
13. Touch the ™ symbol.
The appliance is ready to use.
Fill the water tank with fresh water
If the appliance is not used for a few days, the water in
the water tank should be replaced. The appliance must
be ready for use.
1. Rotate function selector to S.
2. Select "Fresh water replenishment" using the rotary
selector.
3. Touch the ™ symbol.
4. Touch the I symbol.
The tank is emptied and filled with fresh water. Fresh
water replenishment has finished.
5. Touch the ™ symbol.
The appliance is ready for use.
Emptying program
Emptying program
The emptying program is a service program which is
used to remove coffee bean residue and to prevent
damage caused by frost during transportation and
storage. The appliance must be ready for use.
1. Rotate function selector to S.
2. Select "Emptying program" with the rotary selector.
3. Touch the ™ symbol.
4. Empty the bean container and reinsert it.
5. If present, remove the milk container.
6. Close the door.
The emptying program runs for approx. 2 minute.
7. Remove the brewing unit and clean it thoroughly.
8. Clean the drip tray, coffee residue container, milk
system and milk hose set thoroughly, then reinsert
them.
9. Close the door.
10. Touch the ™ symbol.
The emptying program is finished.
Loading ...
Loading ...
Loading ...