Loading ...
Loading ...
Loading ...
To lubricate the articulated steering
joint
1. Lubricate the articulated steering bearing when the
product has all wheels on the ground.
2. Lift the product to release the pressure in the
articulated steering. The illustration shows where to
put the supports.
CAUTION: Make sure that the
support does not cause damage to the
control stay or causes a blockage of the
articulated steering.
3. Lubricate the articulated steering bearing again while
the product is lifted.
4. Lower the product.
To lubricate the drive shaft
1. Remove the service hatch. Refer to
To remove the
service hatch on page 31
.
2. Lubricate the 4 grease nipples with a grease gun
until grease comes out.
Troubleshooting
Troubleshooting
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem Cause
The starter motor does not turn the
engine over
The PTO-button is activated.
The parking brake is not applied. Refer to
To apply and release the parking
brake on page 26
.
The main fuse is blown. Refer to
To replace a fuse on page 38
.
The ignition lock is defective.
The connection between the cable and the battery is bad.
The battery is too weak. Refer to
To charge the battery on page 39
.
The starter motor is defective.
1593 - 006 - 14.11.2022 51
Loading ...
Loading ...
Loading ...