Loading ...
Loading ...
Loading ...
b) Measure Combi 132 X and Combi 155 X in 4
areas. Make sure that the rear edge is 6–9 mm
(¼–⅜ in.) higher than the front edge.
6. Adjust the cutting deck if it is necessary. Refer to
To adjust the parallelism of the cutting deck on page
34
.
To adjust the parallelism of the cutting
deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the
cutting deck. Make the track rod shorter to lower the
rear edge of the cutting deck.
Note: For Combi 132 X, Combi 155 X, adjust the
track rods on the 2 sides.
2. Tighten the nuts on the track rod.
3. Do a check of the parallelism. Refer to
To do a
check of the parallelism of the cutting deck on page
33
.
34 1593 - 006 - 14.11.2022
Loading ...
Loading ...
Loading ...