Loading ...
Loading ...
Loading ...
• Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION: Read the caution
instructions that follow before you use the
product.
• Do not turn over the engine if the spark plug or
ignition cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
• Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. Refer to
Technical data on
page 58
for highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.
Assembly
To attach the cutting deck Combi 132,
Combi 155
Note: Make sure that the cutting deck and the product
are on level ground before you attach the cutting deck.
1. Put the lift lever to the position (B) to lower the lift
arms.
B
A
WARNING: Do not put the lift lever
in the mow position (A). The force from
the lift spring can cause serious injury.
2. Carefully operate the product in front of the cutting
deck.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Stop the engine.
6. Install the bolts (C) and attach the pins (D) on the lift
arms.
D
C
D
C
7. Remove the 2 screws and the service hatch.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the PTO.
Note:
Make sure that the arrow on the symbol
points to the product.
1593 - 006 - 14.11.2022 15
Loading ...
Loading ...
Loading ...