Loading ...
Loading ...
Loading ...
To replace the rear work lights (P 525DX
Cabin)
1. Disconnect the cable from the broken lamp.
2. Remove the screw on the lamp connector.
3. Remove the lamp connector with the lamp attached.
4. Install in the opposite sequence.
To replace the rear lights (P 525DX Cabin)
1. To replace the rear lights, contact an approved
service agent.
To replace the warning lights (P 525DX Cabin)
1. Loosen the wing nut.
2. Remove the lamp.
3. Attach the new lamp.
To do a check of the parking brake
1. Park the product on a hard surface that slopes
maximum 10°.
Note: Do not park the product on a grass slope
when you do a check of the parking brake.
2. Push the parking brake forward.
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Pull the parking brake rearward to release the
parking brake.
To do a check of the parallelism of the
cutting deck
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 40
.
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
a) Measure Combi 132 and Combi 155 in 2 areas.
Make sure that the rear edge is 6–9 mm (¼–⅜
in.) higher than the front edge.
1593 - 006 - 14.11.2022
33
Loading ...
Loading ...
Loading ...