Loading ...
Loading ...
Loading ...
To disengage the hydrostatic
transmission
To move the product with the engine off, you must
open the hydraulic circuits on the front and the rear
transmission. This is done by opening the bypass valves
in the transmission motors.
CAUTION: The product has no brakes
when the bypass valves are open. The
bypass valves must be closed before you
operate the product.
CAUTION: Do not tow the product in
high speed or for long distances. This will
cause damage to the transmissions.
Rear transmission
• To open the bypass valve, open the locknut (A) ¼–½
turn counterclockwise and then the valve screw (B) 2
turns counterclockwise.
A
B
• To close the bypass valve, close the valve screw (B)
and tighten to 8 Nm and then tighten the locknut (A)
to 30 Nm.
Front transmission
• To open the bypass valve, open the locknut (A) ¼–½
turn counterclockwise and then the valve screw (B) 2
turns counterclockwise.
A
B
• To close the bypass valve, close the valve screw (B)
and tighten to 8 Nm and then tighten the locknut (A)
to 30 Nm.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = Maintenance done by the operator. The instructions
are given in this operator's manual.
O = Maintenance done by the service agent. The
instructions are not given in this operator's manual.
Note: If more than one time interval is identified
in the table, the shortest time interval is for the first
maintenance only.
Maintenance
Daily
Week-
ly
First
50 h
Maintenance interval
in hours
100 200 400 800
Make sure that nuts and screws are tightened. *
Make sure that there are no fuel, water or oil leaks. *
Clean the machine. X
Make sure that the safety devices are not defective. X
Lubricate. Refer to
Lubrication overview on page 50
. X
1593 - 006 - 14.11.2022 27
Loading ...
Loading ...
Loading ...