Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
80
Water intake
Health risk and risk of damage
due to contaminated incoming water.
The quality of the water used must
correspond to the drinking water
specification of the country in which
the appliance is being operated.
Always connect the appliance to
potable water.
The washer-dryer must be connected to
a mains water supply in accordance
with current local and national safety
regulations.
The water inlet pressure must be at
least 100kPa and must not exceed an
overpressure of 1000kPa. If the
pressure exceeds 1000kPa, a pressure
reducing valve must be installed.
Connection to the mains water supply
should incorporate a water tap with a
¾" threaded union. If no tap is
available, only a qualified installer may
connect the washer-dryer to the mains
water supply.
The connection point is subject to
mains water pressure.
You should turn on the tap slowly
and check for leaks. Correct the
position of the seal and screw thread
if water escapes.
The washer-dryer is not suitable for
connection to a hot water supply.
Maintenance
Only use a genuine Miele hose that has
been pressure tested to withstand at
least 7,000kPa should you ever need a
replacement.
The dirt filter in the union nut at the
open end of the water inlet hose
protects the water intake valve.
This filter must not be removed.
Hose extension
Longer hoses 2.5m or 4.0m in length
are available from Miele as optional
accessories.
Loading ...
Loading ...
Loading ...