Loading ...
Loading ...
Loading ...
Careandcleaningoftherange.
Do not rub or clean the door gasket--
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it has
become displaced on the door, you should
have it replaced.
C/eening the Oven Door
Todean the inside of the door:
iiiS_
Because tlle area inside tlle gasket is
cleaned during the self'clean cycle, you
do not need to clean this by hand.
The area outside die gasket and
the door liner can be cleaned widl
a seal>filled or plasdc scouring pad,
hot wamr and demrgent. Rinse well
with a vinegar and wamr solution.
To clean the outside of the door:
Use soap and water [o dloroughly
clean the lop, sides and flont of the
oven door Rinse well. You may a/so
use a glass cleaner to clean die glass
iii}i}iiii_
on the outside of die door Do not let
water drip into die vent openings.
If any stain on the door vent tTiIIi is
persistent, use a sol* abrasive cleaner
and a sponge-scrubber fbr best results.
Spillage of marinades, fluitjuices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped
up immediamly. When surface is cool,
clean and rinse.
Do not use oven cleaners, cleaning
powders or ha_h abrasives on die
outside of the door
Slot
Hingeloci<
Pullhingelocksclownto unlock.
Removal position
Lift-Off Oven Door
Thedooris very heavy.Be carefulwhen
removingandliftingthe door.
Donot lift thedoorby thehandle.
Toremovethe door:
%
%
Fully open die door
Pull die hinge locks down toward
die door flame, to die unlocked
position. A tool, such as a small
flat-blade screwdriver; may be
required°
Firmly grasp both sides of die door
at die top.
Close door to die door removal
position, which is halfi,vay bea,veen
die broil stop position and flflly
closed.
[_ Lif* door up and out undl die hinge
arm is clear of the slot.
Toreplace the door:
[_] Firmly grasp both sides of die door
at die top.
%
Wkh die Bottom earm
door at die edge
same angle as ofslot
X
die removal
position, seat die
indenmtion of
die hinge arIn
into die boKom
edge of die hinge
slot. The notch in the hinge arm
must be flflly seared into the bottom
of the slot.
Fully open die dooI: If die door will
not fhlly open, die indentation is
not seated correcdy in the bottoul
edge of the slot.
Push die hinge locks up against
die flont flame of die oven cavity
to the locked position.
Hinge
arm
Hinge
%
Push hinge locks up to lock,
Close die oven door
34
Loading ...
Loading ...
Loading ...