Loading ...
Loading ...
Loading ...
Operator presence control (OPC)
The OPC is engaged when the operator lifts from the
seat. The OPC indicator in the display comes on. The
OPC engages the safety circuit. Refer to
Safety circuit
on page 22
.
Drive mode
The product has 3 available drive modes (Comfort,
Standard and Dynamic). Standard drive mode is set
from the factory. The last selected drive mode is saved.
To select a drive mode refer to
To select a drive mode
on page 36
.
PTO (Power Take-Off) button
The PTO button engages and disengages the PTO
clutch and the cutting deck or other equipment
connected to it. The correct start conditions must be
obeyed to engage the drive of the blades. Refer
to
Safety circuit on page 22
for the correct start
conditions.
• Pull the PTO button out to engage the drive to the
blades or other equipment.
• Push the PTO button in to disengage the drive to the
blades or other equipment.
Note:
The maximum forward and reverse speed is
lower when the drive to the blades is engaged. The
pedals must be released after the drive to the blades
is engaged or disengaged to enable the speed change.
Refer to
Forward and rearward pedals on page 9
.
PTO speed switch
The PTO speed switch can be set in 3 positions for
operation with different types of cutting decks or other
equipment. When the PTO button is engaged, the
engine speed is supplied to the cutting deck or other
equipment that is attached to the PTO shaft. Refer to
To
set the PTO speed on page 37
and
Technical data on
page 67
.
Note: For operation with cutting decks, use the high
PTO speed.
Forward and rearward pedals
The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
(B) is used to move rearward. The product brakes when
the pedals are released.
B
A
The product operates at a different maximum speed
when the PTO-button is engaged or disengaged. The
speed change is enabled when you release the pedals.
Refer to
PTO (Power Take-Off) button on page 9
and
Technical data on page 67
for information about
maximum speed.
Lever for the hydraulic lifting arms
The lever for the hydraulic lifting arms is used to lift and
lower the cutting deck and other equipment.
A
B
C
D
WARNING:
It is possible to lower the
hydraulic lifting arms after you stopped the
product. Make sure to stop the product
1591 - 008 - 12.12.2022 9
Loading ...
Loading ...
Loading ...