Loading ...
Loading ...
Loading ...
3. Move the lever for the hydraulic lifting arms rearward
to fully lift the hydraulic lifting arms.
4. Turn the power key to the STOP position.
5. To increase or decrease the ground pressure,
remove the pin and the bolt and move the gas spring
to 1 of the positions.
A
B
C
D
a) Use position (A) for the lowest ground pressure.
Position (A) is used for example when a cutting
deck is attached to the product.
b) Use position (B) or (C) for increased ground
pressure.
c) Use position (D) to disengage the gas spring.
Position (D) is used for example when a snow
blade is attached to the product.
To adjust the cutting height - Combi
155
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lifting arms rearward
to fully lift the cutting deck.
4. Turn the power key to the STOP position.
5. Remove the cutting height adjustment knob on the
side of the cutting deck.
6. Put the cutting height adjustment knob in 1 of the
holes on the adjustment plate.
Note:
The cutting height is shown with the
numbers 1-7. Refer to the table below.
Number Cutting height, mm/in
1 30/1.2
2 40/1.6
3 52/2
4 64/2.5
5 76/2.3
6 93/3.7
7 112/4.4
7. Tighten the cutting height adjustment knob.
8. Do steps 5-7 on the other side of the cutting deck.
9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note:
Make sure the same number is selected on
all 3 adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to
To adjust the parallelism of the cutting deck on page
57
.
To adjust the cutting height - Combi
155 X
1. Park the product on level ground.
2. Move the lever for the hydraulic lift arms forward to
lower the cutting deck to ground position.
3. Set the auxiliary power switch to position "1".
38
1591 - 008 - 12.12.2022
Loading ...
Loading ...
Loading ...