Loading ...
Loading ...
Loading ...
CAUTION: Do not use the product if
the temperature in the 48 V batteries are
less than 0 °C/32 °F.
WARNING: When the hydraulic
motor stops, the product is in operation
and without noise. If the manual parking
brake is not engaged, the product moves
if you push the forward or rearward
pedal.
Note: If you get a fault indication when the product
is in electrical drive, you must push the start button
for the electrical drive again. For example if you lift
from the seat and the manual parking brake is not
engaged.
4. Push the start button for the hybrid drive (B) to start
the engine.
Note: You can also start the hybrid drive directly,
without the electrical drive is on, if the product is
stationary.
To do a preheating of the product
If the product is in storage in a cold environment, the
internal temperature of the 48 V battery can become
too low to let the product operate correctly. It is then
necessary to do a preheating procedure.
If the internal temperature is between -15°C and 0°C,
the product can be moved at low speed to an applicable
location for the preheating procedure. Only use the
hybrid mode. If the internal temperature is lower than
-15°C, it is not possible to move the product or do the
preheating.
CAUTION:
Preheating uses the diesel
engine and must be done outdoors or in an
area with sufficient airflow.
1. If the internal temperature of the 48 V battery
is lower than -15°C, wait until the temperature
increases above -15°C.
2. Make sure that the product is in an applicable
location.
3. Start the product.
4. Set the PTO speed switch to high speed.
5. Push the hybrid button to start the hybrid mode and
to start preheating.
The preheating continues until the internal temperature
of the 48 V battery is above 0°C. The display shows the
status of the preheating process.
Note:
Do not use the product during the preheating
process.
To stop the product
1. Park the product on level ground.
2. Apply the manual parking brake.
3. If the cutting deck is engaged, push the PTO button
to disengage the drive on the cutting deck.
4. Push the lever for the hydraulic lifting arms forward
to lower the cutting deck to the ground.
5. Turn the power key to the STOP position. The
hydraulic system pressure releases.
Note:
To stop the hybrid drive only, push the start
button for the electrical drive.
1591 - 008 - 12.12.2022 35
Loading ...
Loading ...
Loading ...