Loading ...
Loading ...
Loading ...
1. Remove the screws that attaches the ROPS to the
product.
180°
2. Turn the ROPS 180 degrees.
3. Install the ROPS with the screws. Tighten the M16
nut to 47 Nm.
4. Engage or disengage the ROPS. Refer to
To engage
and disengage the Roll Over Protection Structure
(ROPS) on page 31
.
To engage and disengage the Roll
Over Protection Structure (ROPS)
• Remove the 2 bolts that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING: Obey the following
instructions for the ROPS and the seat
belt.
• Do not use the seat belt if the ROPS is disengaged.
• Always use the seat belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.
Operation
Introduction
WARNING: Before you operate the
product, you must read and understand the
safety chapter.
Display
Time, language and system menu
When you start the product for the first time, the
language and time menu open automatically. After that
first time, you can get access to the time, language and
system menus through the display.
1591 - 008 - 12.12.2022 31
Loading ...
Loading ...
Loading ...