Loading ...
Loading ...
Loading ...
4. Do a check of the coolant level. Fill the coolant tank
if it is necessary. Refer to
Technical data on page
67
.
5. Do a check of the coolant level in the expansion
tank. The level must be at the LOW mark when the
engine is cold.
Tire pressure
Refer to
Technical data on page 67
for the correct tire
pressure.
Cutting deck - C132, C155
To put the cutting deck in servicing position
1. Do the procedure in
To remove the cutting deck on
page 29
but do not disconnect the lift arms.
2. Remove the service stay from the cutting deck.
WARNING: Attach the service stay
and the safety straps when the cutting
deck is in servicing position. To not use
the service stay or safety straps correctly
can result in serious injury or death.
3. Attach the service stay to the red point below the
bottom plate.
4. Pull the pin on the other end of the service stay.
Attach the service stay to the red mark on the pipe
on the cutting deck.
5. Start the engine.
6. Move the lever for the hydraulic lift arms rearward to
lift the cutting deck fully.
1591 - 008 - 12.12.2022
55
Loading ...
Loading ...
Loading ...