Loading ...
Loading ...
Loading ...
12. Adjust the parallelism of the cutting deck. Refer to
To adjust the parallelism of the cutting deck on page
59
.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
40
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
Technical data on
page 67
). Move the product forward at low speed.
If the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip
®
function.
• The turning radius is smaller to the left than to the
right. Turn left if you cut near and around objects.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = Maintenance done by the operator. The instructions
are given in this operator's manual.
O = Maintenance done by the service agent. The
instructions are not given in this operator's manual.
Note: If more than one time interval is identified
in the table, the shortest time interval is for the first
maintenance only.
Maintenance
Daily
Wee
kly
First
50
hours
Maintenance interval
in hours
200 400 800
Make sure that nuts and screws are tightened. *
Make sure that there are no fuel, water or oil leaks. *
Clean the product. Refer to
To clean the product on page 46
. X
Make sure that the safety devices are not defective. Refer to
Safety
devices on the product on page 21
.
X
Lubricate as shown in the quick maintenance guide. Refer to
Quick
maintenance guide on page 42
.
X
Make sure that the fuel hoses and the couplings are clean and not
damaged.
1
* *
Make sure that the hoses for the cooling system and the couplings
are clean and not damaged.
* *
Examine the 12 V battery. *
Do a check of the electrical connections and cables. * *
Control the pedal linkage, adjust and grease. O
Examine and adjust the brake wire. O
Make sure that the cold air intake of the battery cooling system is not
blocked.
X X X
1
Fuel hoses must be replaced every 5 years.
40 1591 - 008 - 12.12.2022
Loading ...
Loading ...
Loading ...