Loading ...
Loading ...
Loading ...
installation anstructions (continued)
Step 9
Installing the Anti-Tip Device
WARNING:
. Range must be secured with an approved Anti-
Tip device,
• Unless properly installed, the range could be
tipped by you or a child standing, sitting or lean-
ing on an open door°
o After installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward,,
•This range has been designed to meet all recog-
nized industry tip standards for all normal condi-
tion&
° The use of this device does not preclude tipping
of the range when not properly installed°
• If the Anti-Tip device supplied with the range
does not fit this application, use the universal
AntFTip device WB02X7909,
1. Mark the walt where the RIGHT EDGE of the range
is to be located. Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets.
_.__ Anti-Tip I
_r_f/l_lll Device I
Slotted _-_ 1_!_-.. _ I
head _-ULII 1
crew wo,,p,atoI
App_ox2o__4.L.._ i
J.-2y¢" ,/"/Marked edge of range
€,b.qcm) _,,
J
2. Locate the outside edge of the device 2¼" (5,,4 cm)
toward the center of the range from the marked edge
of the range
3. Using the device as a template, mark the position of
the hole for the screw.
4. For wood construction, drill a pilot hole at an angle of
20 degrees from the horizontal. A nail or awl may be
used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need a
1/4" x 1½" lag bolt and a 1/2" O.,D, sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device,. The bolts
must be properly tightened as recommended for the
hardware,
Wallboard Back of range
Anti-Tip
Device
Wood screw
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of
the rear surface unit openings and carefully
attempting to tilt the range forward.,
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF THE CONTROLS ARE
LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED,
42
Loading ...
Loading ...
Loading ...