Loading ...
Loading ...
Loading ...
Broiler Pan and Grid
After broiling, remove the
broiler pan from the oven
or broiler compartment
(depending on your model).
Remove the grid from the
pan. Carefully pour out
grease from the pan into a
proper container. Wash and
rinse the broiler pan and
grid in hot water with a
soap-filled or plastic scour-
ing pad.
If food has burned on, sprinkle the grid with deter-
gent while hot and cover with wet paper towels or a
dishcloth. Soaking the pan will remove burned
OFz _JOQS.
!!
Both the broiler pan and grid can also be cleaned in
the dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
Do not clean the broiler pan or grid in the
self-cleaning oven.
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool. After cleaning, rinse the shelves with clean
water and dry with a clean cloth..
NOTE: Take the shelves out of the oven before you
begin the self-clean cycle.
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier,
protect the oven bottom
from excessive spillovers
by placing a cookie sheet
on the shelf below the
shelf you are cooking on.
You can use aluminum foil
if you do not cover the
whole shelf° This is partic-
ularly important when
baking a fruit pie or other foods with a high acid con-
tent. Hot fruit fillings or other foods that are highly
acidic (such as milk, tomatoes or sauerkraut and
._au..._s _.,,h v, ,_ua, ,,, lemon r','-=J may cause -""--
- F'=";:_Y
and damage to the porcelain enamel surface and
should be wiped up immediately.
To clean up spi]lovers, use soap and water, an abra-
sive cleaner or scouring pad. Rinse well to remove
any soap before self-cleaning.
Surface Light and Starter (onsome models)
CAUTION: Do not touch Canopy
the bulb with wet hands
or when bulb is hot.
Never wipe the light Lift up
area with awet cloth.
Electrical power must
be shut off if you have Starter
to replace abulb.
To replace the bulb:
1. With one hand at each
end of the hinged Light bulb
canopy, grasp it by the
front edge and flip it up.
2. Remove the fluorescent light bulb.. Replace the bulb
with one of the same length and wattage.
3. Lower the canopy,
To replace the starter:
1, Open the canopy and remove the bulb as explained
above°
2. Grasp the starter, turn it counterclockwise about
one-quarter turn and lift out° Replace with one of
the same wattage.
3. Replace the bulb and lower the canopy.
(continued next page)
29
Loading ...
Loading ...
Loading ...