Loading ...
Loading ...
Loading ...
(67,1)
北米Model "A1525BE-A" EDITED: 2023/ 4/ 24
7. Before having a child sit in the child
restraint system, try to move it back
and forth and right and left to check if it
is firmly secured. Sometimes a child
restraint system can be more firmly
secured by pushing it down into the
seat cushion and then tightening the
seatbelt. It should not be possible to
move the child restraint system more
than 1 in (2.5 cm) in any direction along
the seatbelt path.
8. Pull at the shoulder portion of the belt
to confirm that it cannot be pulled out
(ALR properly functioning).
9. Attach the tether hook onto the tether
anchorage and tighten the tether strap
firmly. For additional instructions, refer
to “Tether Anchorages” �P72.
10. To remove the child restraint system,
press the release button on the seat-
belt buckle and allow the belt to retract
completely. The belt will return to the
ELR mode.
If you have installed a child restraint
system for the rear center seating posi-
tion, when you remove the child restraint
system, the seatbelt may not be restored
to the ELR mode even if the seatbelt is
retracted. In this case, lower the head
restraint to the retracted position to allow
the seatbelt to retract moreover. The
seatbelt will return to the ELR mode.
Remember that the head restraint is not
intended to be used at the lowest position
(retracted position). Therefore, when the
rear center seat is occupied (including
when a child restraint system is installed)
next time, be sure to raise the head
restraint to the extended position.
NOTE
When the child restraint system is no
longer in use, remove it and restore the
ELR function of the retractor. That
function is restored by allowing the
seatbelt to retract fully.
– CONTINUED –
Child Restraint Systems
65
1
Seat, Seatbelt and SRS Airbags
Loading ...
Loading ...
Loading ...