Loading ...
Loading ...
Loading ...
B
0
o
o
u,
2
©
2
F' i
o
* Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
* Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
* About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit net to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
* Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
* Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
* Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
..................................Note:
Uz:_
11;
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
"//////////////////////////////////////////////////
•_ Note
X////////////////////////////////////////////////×
In addition to the AVR-589, the included remote control unit (RC-1104)
can also be used to operate the equipment listed below.
@} DENON system components
Non-DENON system components
o By setting the preset memory (L_page 42 ~ 44)
@_ Lift the clasp and remove the rear lid. _,_
Load the two batteries properly as indicated f_,.._¢_.'---.._
by the marks in the battery compartment, f_o'o_ _"'_
m6/AA '__'_
@ Put the rear cover back on.
* Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
* The supplied batteries are only for verifying operation.
* When inserting the batteries, be sure to do so in the proper direction,
following the "0" and "@" marks in the battery compartment.
o To prevent damage or leakage of battery fluid:
o Do not use a new battery together with an old one.
o Do not use two different types of batteries.
o Do net attempt to charge dry batteries.
o Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
o If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
o Remove the batteries from the remote control unit if it will not be in
use for long periods.
oWhen replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
Point the remote control unit at the remote sensor when operating it.
30 °
-..
Approx. 23 feet / 7 m
'-....
The set may function _mproperly or the remote control unit may net
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or infrared
light.
Wall
3
Loading ...
Loading ...
Loading ...