Loading ...
Loading ...
Loading ...
©
2
7
o
5'
©
if
U_
Example: 5.1-channels
I Subwoofer I
Subwoefer
with built-in
amplifier
•_ L • Left
R Right
I Front speakers
A I Center speaker II
9
Surround speakers !
Carefu cnec_ _ne eft _ ana rlgm _D channels
ana - real an(3 -- DlaCI _ oolarltles on ;ne sloeaKers
being cennectea ;e ;ne AVR-S89 ana De sure to
merconnect tne cnannels and ioolarltles correc_ .,
Peel off about 0.03 ft/10 mm _._
of sheathing from the tip of
the speaker cable, then either N
twist the core wire tightly or
terminate it.
Turn the speaker terminal _x
counterclockwise to loosen _)M
Insert the speaker cable's
core wire to the hilt into the
speaker terminal.
Turn the speaker terminal
clockwise to tighten it.
When using a banana plug
Tigmen ;ne 3beaKer termlna _;_
inseRing me Danana plug.
before
" Jse sloeaKers NlIn an _oeaance of 6 _o 16
enms When uslnc front _ ana B speakers
slmul;aneous Jse sloeaKers NIIn at _Deqance
of 12 to 16 _/ehms.
o Connect the speaker cables in such a way that
they do not stick out of the speaker terminals.
The protection circuit may be activated if the core
wires touch the rear panel or if the + and - sides
touch each other (_ "Protection circuit").
oNever touch the speaker terminals while the
power supply is connected. Doing so could result
in electric shock.
If the core wires touch the rear panel and the
screws etc., or the + sides touch each other, the
)retection circuit will be activated and the power
indicator will flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned
off, after the power supply cord is withdrawn,
)lease confirm that speaker cable and input cable
are connected.
Also, if replaying large sound levels by using
a speaker having an impedance less than that
specified (eg, 4 _/ohms), the temperature will
rise, and the protection circuit might be activated.
The power supply will go into the standby state,
and the power indicator will flash red at 2 second
intervals.
In this case, please switch off the power supply,
and wait until the AVR-589 has cooled down, and
the surrounding ventilation is good.
Even if there are no problems with the surround-
ing ventilation and connections, in the event of
the protection circuit becoming activated, due to
thinking that the AVR-589 has failed, please con-
tact DENON Service center after switching off.
Loading ...
Loading ...
Loading ...