Loading ...
Loading ...
Loading ...
o
©
F'
o i
o
o
o
d
Step 4 : Check ,)
When analysis is complete, "Parameter Check<" is displayed•
Press <::]and check the analysis results for the following four items•
C1)Make your selection using AV and press <::]•
o Presence and size of speaker
"SpConfig. Check<"
o Distance of speaker from listening position
"Distance Check<"
o Speaker channel level
"Ch Level Check<"
• Crossover Frequency
"Crossover Check<"
C_ Use A or V to change which speaker is displayed•
To switch to another analysis result item
Press ENTER.
This returns you to analysis results items, so repeat operation _•
[_1To proceed to "Step 5 : Store"
During display of crossover frequency result or analysis results item, press ENTER.
* "Store<" is displayed•
*To proceed to "Step 5" without checking the analysis result, use A V to select "Store<"
while "Parameter Check<" is displayed.
* Values that are different from the actual distance may be set for speakers with built-in filters
(subwoofers, etc). This is because filters add electrical delay to the signal that should be
compensated.
CStep 5 Store
The auto setup measurement results are stored in the AVR-589•
C1)Press <::]while "Store<" is displayed.
• "Storing" blinks on the display panel while the results are being stored.
• When storing is complete, "Completed" is displayed followed by "Disconnect Mic'•
C_ Disconnect the setup microphone from the AVR-589•
To cancel storing
Use A or V to display "Cancel<" while "Store<" is displayed and press <::].
* All the measured auto setup data will be erased•
De net turn the power off while the settings are being stored•
i:::ii"i i:::,i _iii!ii 'i:: i".i O i :iii:_iii!
C .iii__..._4::i,:::,i._:: :iil;F i".i,:::,i_ ,iii_
I The messages alternate
i:::i:;i:
C ,iiiiu ,,i::i o i,i :: R h ,iiii:iii:E!
l The messages alternate
:iil;i....
*Theincluded setup microphoneis not
connected•
* Not all speakers could be detected•
Too much noise in the room for
accurate measurements to be made.
Speaker or subwoofer sound is too
low for accurate measurements to be
made•
Displayed speaker could net be
detected.
• The front L and front R speakers
were not properly detected•
• Only one channel of the surround
speakers was detected•
Displayed speaker connected with
the polarities reversed•
* Connect the included setup
microphone to the SETUP MIC jack
on the main unit.
* Check the speaker connections•
* Either turn off any device generating
noise or move it away.
*Try again when the surroundings are
quieter•
* Check the speaker installation and the
direction in which the speakers are
facing.
* Adjust the subwoofer's volume•
Check the connections of the
displayed speaker•
Check the polarities of the displayed
speaker.
For some speakers, this error
message may be displayed even if the
speaker is properly connected• If the
connection is correct, use the A or V
buttons to display "Skip<" and then
press <::].
Select "Retry" to make the measurements again•
_Be sure to turn the power off before checking speaker connections•
19
Loading ...
Loading ...
Loading ...