Loading ...
Loading ...
Loading ...
206
Parking and manoeuvring
Note
The exterior mirrors cannot be adjusted while
the assist
ant is active. The saved setting
for the passenger’s mirror can be activated
›››page110.
Troubleshooting
Camera with no visibility, fault message, the
system disconnects
●
Clean the camera or remove possible adhe-
siv
es or accessories from it ›››page335.
●
Check for visible damage.
The system behaves dierently than expec-
ted
There can be several causes:
●
The camera is dirty ›››page335. In addi-
tion t
o dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
●
The system requirements must be met
›››page204.
●
The camera is covered with water.
●
The vehicle has some type of damage in the
camera area, e.g. due to a parking impact.
●
The fiel
d of view of the camera is blocked by
an accessory, e.g. a bicycle carrier system.
●
Changes have been made to the paint in the
camer
a area and structural modifications have
been made, e.g. to the front part of the vehicle
and the running gear.
Solution for all cases
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the system still behaves unpredictably,
have it checked by a specialised workshop.
Rear cross trac alert
(RCTA)
How it works
Fig.149 Diagr
am of the parking assistant:
detected area around the vehicle that is driving
o.
Park Assist uses the radar sensors on the rear
bumper ›››page156 t
o monitor trac cross-
ing behind the vehicle as it reverses out of a
parking bay, or as it is being manoeuvred, for
example in very low visibility conditions.
When the system detects a relevant vehicle on
the road that is approaching the rear of the ve-
hicle ›››Fig.149, an acoustic alarm may sound
if the relevance so requires it.
In addition to the acoustic alarm, the driver is
also informed by means of a visual signal on
infotainment system display. This signal is dis-
Loading ...
Loading ...
Loading ...