Loading ...
Loading ...
Loading ...
Figure 78
To guard against loosening of the taper shank while the
drum is in operation, it is advisable to support the free end,
using either a ballbearing or plain 60 ° center in the tailstock.
USE OF WOOD CHUCKS FOR SANDING
Quick-acting chucks can be very useful for sanding operations
on duplicate production parts. The chuck is made slightly
oversized, and a piece of rubber hose (for small parts) is
inserted in the recess to grip the workpieces. Workpieces can
be changed without stopping the lathe.
Figure 79
WARNING: Make certain that the unit is disconnected from
power source before attempting to service or remove any
component.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool. Keep centers clean. Check inside belt
guard to make sure that saw dust has not accumulated.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts and
plastic guards.
LUBRICATION
The shielded ball bearings in this tool are permanently lubri-
cated at the factory. They require no further lubrication.
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, have it
replaced immediately.
• Replace any damaged or missing parts. Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician. Repair service
is available at your nearest Sears store.
21
Loading ...
Loading ...
Loading ...