Loading ...
Loading ...
Loading ...
Know What the Presser Feet Will Do
= Check the Presser Foot
The presser leet are an important leature oi this machine. You need to know
what each foot does in order to use them effectively.
Your presser foot is held in place by a toot holder. Each presser toot merely
snaps on the toot holder, which is seldom removed.
If you need to remove or attach the toot holder, here is what you do:
To Remove:
Foot _ !
ho_der_
SCreW
J
To Remove:
Turn the screw toward the back o|
the machine. Use the large screw
driver.
To Attach:
Presser b_
To Attach:
1. Match the hole in the loot holder
with the threaded hole in the
presser bar.
2. Fit the toot holder screw into the
hole.
3. Tighten the screw by turning it
toward you.
o Change the Presser Foot
Use the correct presser toot for the stitch you wish to sew. Consult the Stitch
Pattern Chart and the detaited directions for sewing with the various presser
leer.
To Snap Off:
f
f
Snap*on
bu[|on
To Snap Off the Presser Foot:
1. Raise the needle bar to its highest
position by turning the hand wheel
toward you.
2. Raise the presser foot.
3. Press the snap-on button on the
back of the toot holder.
The presser foot will drop off.
x.
To Snap On:
f
To Snap On the Presser Foot:
1. Place the presser toot so the hod-
zontal pin on the toot lies just under
the groove of the toot holder.
2. Lower the presser foot holder to lock
the presser loot in place.
NOTE: If you do not hear the presser
foot snap in place, press
down on the presser loot
holder firmly until you hear
the snap.
13
Loading ...
Loading ...
Loading ...