Loading ...
Loading ...
Loading ...
General
Cleaning
• Cooktop Cleaning
To Clean the Burner Grates, Contoured Burner Pans, Burner Cap, and
Burner Base
The burner grates, contoured burner pans, burner cap, and burner base should be
routinely cleaned. Keeping the burner ports clean will prevent improper ignition and
an uneven flame. Follow instructions below.
To Clean the Contoured Burner Pans
The square burner pans are attached to the cooktop and are not removable. The
burner pan forms a recessed well area located around each burner unit. If a spill occurs
in one of the four well areas, blot up spill with an absorbent cloth. Rinse with a clean,
damp cloth and wipe dry.
To Clean the Grates
The burner grates and wok stand are dishwasher safe. Any remaining soil may be
removed by gently scouring with a soapy scouring pad. Rinse with a 1:1 solution of
clean water and ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, then
scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth. Remove
all cleaners thoroughly or the grate porcelain may become damaged during future
heating. DO NOT use spray oven cleaners.
To Clean the Burner Cap
Use a soap-filled scouring pad or a mild abrasive cleanser to clean burner caps. If
necessary, cover stubborn spots with an ammonia-soaked paper towel for 30 minutes.
Rub gently with a soap-filled scouring pad and rinse with a mixture of clean water and
vinegar. Wipe dry. Remove all cleaners thoroughly or the burner cap porcelain may
become damaged during future heating.
To Clean the Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned. Use a small-
gauge wire or needle to clean small slots or holes. Use care to prevent damage to the
electrode. If a cleaning cloth should catch the electrode, it could break or damage
the electrode. If the electrode is damaged or broken, the surface burner will not light
because it will not spark. Manual lighting with a match is still possible.
For proper flow of gas and ignition of the burner--DO NOT ALLOW SPILLS,FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Gas must
flow freely through the small hole in the brass orifice for the burners to light properly.
If the gas opening orifice becomes soiled or clogged, use a small-gauge wire or needle
to clean. ALWAYS keep the burner cap assembly and ring in place whenever a surface
burner is in use.
After cleaning make sure each burner cap is properly aligned and level. Turn the
burner on to determine if it will light. If the burner does not light after cleaning,
contact a Sears Service Center. Do not service the sealed burner yourself.
18
Loading ...
Loading ...
Loading ...