Loading ...
Loading ...
Loading ...
4.3 MAINTENANCE OF THE COMPRESSOR COMPARTMENT
4.3.1 CONDENSER MOTOR FAN REPLACING
Move to the back of the cabinet and remove the rear grill as
previously described.
Disconnect the motor fan by disconnecting the terminal
junction and remove the terminals from the junction,
proceeding as already explained in the paragraph 4.1.1 in
fig. 26.
Remove the hexagonal-head screws securing the motor fan
support to the base plate using a 10 mm spanner. Let the
motor fan move to one side of the compressor, as shown in
fig. 51; unscrew the hexagonal-head screw fixing the blade
to the motor and remove the screws fastening the motor to
its metal support.
FIG. 51
- 30 -
4.3.2 LOW PRESSURE PRESSOSTAT REPLACING
Move to the back of the cabinet and remove the rear grill as previously described.
Empty the refrigerating circuit, recovering the refrigerant into a suitable container to re-use it
later. Release the pipe and the capillary tube from the welds shown in figure 52a.
Remove the pressostat cap by loosening the fixing screw highlighted in fig. 52b and disconnect
the wires from the pressostat terminals: take note of the position of each wire, in order to
restore them later in the right way. For any information always refer to the wiring diagram
SE211/06.
FIG. 52a
Capillary weld
FIG. 52b
Cap
Cap fixing screw
blue cable terminal
white cable terminal
Loading ...
Loading ...
Loading ...