Loading ...
Loading ...
Loading ...
2.3 MECHANICAL AND ELECTRICAL COMPONENT PARTS IN THE
TANK
The refrigerator is supplied with separate shelves (68): their position in the tank can be set
as desired by moving the 4 shelf supports (70) on
the four fixed racks (16) inside the tank; a bottom
shelf (67) keep the product lifted from the tank floor
for a correct air circulation.
In the tank there are two 36 W neon tubes (34),
protected by polycarbonate shields (54); these
neon tubes are positioned on the sides of the tank,
behind the door.
On the top of the tank there is the plastic
evaporator cover (8) on which the internal motor
fan protection grill (28) is secured; a metal grill (27)
keep the product spaced from the back wall for a
correct air circulation.
To reach the mechanical component parts in the tank, it is
necessary to disassemble the evaporator cover (8): remove the
screws marked with "2" in fig. 4, in order to loosen the draining
tube plastic stopper (46) marked with "1"; then remove the rear
metal cover sheet, by removing the 9 screws shown in fig. 5, 6, 7
and 8, and loosen the screws marked with "1" in fig. 10, in order
to remove the plastic toggle-joint (6) marked with an arrow in the
same figure; at the end loosen the plastic draining tube (7) and
remove the evaporator cover (8).
FIG. 4
FIG. 5
FIG. 7
FIG. 8
FIG. 6
- 12 -
Loading ...
Loading ...
Loading ...