Loading ...
Loading ...
Loading ...
3.1 START-UP INSTRUCTIONS
After removing the packaging and installing
the refrigerator in its final location, adjust the
level feet (43) until the refrigerator is locked in
place, on a flat surface.
In figure 23 one of the 2 front feet is shown
rested on the ground: make sure that the
refrigerator is perfectly installed on a flat
surface, since the automatic closure system
of the door might work improperly.
Plug into a suitable electric socket able to receive the type of plug supplied with the
appliance.
Be sure that the electrical supply voltage is equal to that on the rating plate of the
refrigerator.
Once you have plugged in, it is possible to start the refrigerator by pushing the main switch
button; if the switch green led is on and, at the same time, the red defrosting light is on,
the freezer is in defrosting cycle: then, to start the cooling phase, operate on the timer cam
or wait for about 15 minutes until this phase is over.
When the machine starts the cooling phase, the defrosting red led is switched off and the
compressor starts to operate, but the internal fan do not start immediately, until it is
enabled to start by the end-of-defrosting thermostat (KFS) (5): the delay-action of the
internal fan prevents the compressor for being overheated and allows to safeguard its
functioning.
Therefore, when the machine is started for the first time, it is absolutely normal that the
internal fan does not start: it is necessary to wait for about 10-15 minutes to see it coming
into operation.
When the inside temperature reaches the value set by the thermostat (TC) (80), the
compressor stops and begins the thermostatic cycles to maintain the desired temperature.
This machine is designed to preserve ice-creams or frozen food and it is not suitable for
freezing cycles: therefore, do not load the machine with food to be frozen but only with
already frozen food.
Do not load food into the machine if the inside temperature is not stabilized to the value
necessary for preserving it: after starting the machine, wait for at least 1 hour before
loading products.
FIG. 23
- 20 -
Loading ...
Loading ...
Loading ...