Loading ...
Loading ...
Loading ...
4.2.6 EVAPORATOR REPLACING
Remove the evaporator cover (8) and the back metal cover in
the rear side of the cabinet, as already explained at paragraph
2.3 and 2.5.
Empty the refrigerating circuit, recovering the refrigerant into a
suitable container to re-use it later.
From the back of the cabinet remove the plastic insulated cover
box (15) by unscrewing the 4 screws shown in figure 45.
Remove the sealing coat, marked with a circle in figure 46,
covering the hole at the top near the welded joints and release
the pipe and the capillary tube from the welds always shown in
figure 46.
Remove the evaporator heater and the end-of-defrosting
thermostat as already described in the previous paragraphs.
Inside the tank remove the screws shown in fig. 47, 48, 49 and 50,
that fix in position the evaporator; pull backwards and, at the same
time, lower the evaporator until the pipes connecting it to the
thermodynamic circuit are completely inside the tank.
FIG. 45
FIG. 46
FIG. 47
FIG. 48
FIG. 49
FIG. 50
- 29 -
rear right screw
rear left screw
front left screw
front right screw
Loading ...
Loading ...
Loading ...