Loading ...
Loading ...
Loading ...
42
Descale
The appliance must be descaled regularly in order for it
to continue operating correctly.
There are several steps in the descaling program. For
hygiene reasons, the descaling program must be run
through completely so that the appliance can be ready
for operation again. In total, the descaling program runs
for approx. 70-90 minutes.
▯ Descale (approx. 55-70 minutes)
▯ First rinsing cycle (approx. 6-9 minutes)
▯ Second rinsing cycle (approx. 6-9 minutes)
If descaling is interrupted (for example, due to a power
failure or because the appliance is switched off), you are
prompted to rinse the appliance twice after it is switched
back on. The appliance cannot be used until the second
rinsing cycle comes to an end.
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only five more steam-assisted operations are
possible, or fewer, the appliance reminds you to descale
it with a message on the display. The number of
remaining operations is displayed after the appliance is
switched on. You can therefore prepare for the descaling
in good time.
Start
NOTICES
▯ Only use the descaler recommended by Thermador
for the descaling program. Other descalers may
damage the appliance.
Descaler order no. 10008170
▯ If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
▯ Descaling solution: Do not allow the unmixed
descaling chemicals or mixed solution to come into
contact with the control panel or other surfaces on the
appliance as prolonged exposure may cause damage
to the surfaces. Immediately remove any descaler by
rinsing with tap water.
1.
Mix 32 fluid oz. (950 ml) of water with 1/2 bottle
(approximately 200ml) of descale solution.
Note: Mix ratio may vary from packaging.
2.
Turn the function selector to CLEAN MODES.
3.
Swipe to the left or right to select "Descale ,".
4.
Touch “continue”.
The duration of the descaling program is displayed. It
cannot be changed.
5.
Touch “continue” again.
6.
Following the display prompt: Remove the water tank
and fill it with descaling solution, then reinsert tank.
7.
Press Start.
The appliance will now be descaled. The remaining
time counts down on the display. As soon as the
descaling program has finished, an audible signal
sounds.
First Rinsing Cycle
1.
The display will prompt to open the appliance door.
Remove the water tank and rinse thoroughly. Fill the
tank with fresh water and reinsert.
2.
Close the appliance door.
The first rinse will begin automatically once the door is
closed. When complete an audible sound will be
heard and the display will prompt for the next step.
Second Rinsing Cycle
1.
The display will prompt to open the appliance door.
Remove the water tank and rinse throughly. Fill the
tank with fresh water and reinsert.
2.
Close the appliance door.
The second rinse will begin automatically once the
door is closed. When complete an audible sound will
be heard and the display will prompt for the next step.
Completing Descale
1.
Open the appliance door.
2.
Empty water tank. Rinse thoroughly. Dry and reinsert.
3.
Descaling is complete and the appliance is ready for
use again.
Loading ...
Loading ...
Loading ...