Loading ...
Loading ...
Loading ...
CVP-709/CVP-705 Owner’s Manual
110
CVP-705 Assembly
4 Secure A.
1 Adjust the position of A so that the left and right ends of A
will project beyond D and E equally as shown in the
illustration.
2 Attach A using six screws J.
5 Connect the pedal cord and power cord.
1 Insert the pedal cord plug into the pedal connector.
Insert the pedal cord securely
until the metal part of the cord
plug disappears from view.
Otherwise, the pedal may not
function properly.
2 Attach the cord holders to the rear panel as shown, then clip
the cord into the holders.
3 Use a vinyl tie to take up any slack in the pedal cord.
4 Insert the AC power cord plug into the [AC IN] jack.
6 Rotate the adjuster until it comes in firm
contact with the floor surface.
7 Attach the headphone hanger.
Attach the headphone hanger using two screws K as
shown in the illustration.
A
A
J
D
E
1
2
2
3
4 1
After completing the assembly, please check the following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable
fixtures?
→ Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you step on
the pedals?
→ Turn the adjuster so that it is set rmly against the oor.
• Are the pedal and power cords inserted securely into
the sockets?
CAUTION
When moving the instrument, always hold the bottom of the
main unit. Do not hold the key cover or top portion. Improper
handling can result in damage to the instrument or personal
injury.
Transporting
If you move to another location, you can transport the
instrument along with other belongings. You can move the unit
as it is (assembled) or you can disassemble the unit down to the
condition it was in when you first took it out of the box.
Transport the keyboard horizontally. Do not lean it up against a
wall or stand it up on its side. Do not subject the instrument to
excessive vibration or shock. When transporting the assembled
instrument, make sure all screws are properly tightened and
have not been loosened by moving the instrument.
CAUTION
If the unit creaks or is otherwise unsteady when you play on
the keyboard, refer to the assembly diagrams and retighten all
screws.
K
Do not hold here.
Hold here.
Loading ...
Loading ...
Loading ...