Loading ...
Loading ...
Loading ...
58
PAGE HEADER.....
TROUBLESHOOTING
PROBLEM EASY SOLUTION
EO is displayed on
LED Screen
• Check that lid is closed properly.
• Check that the Pressure Release Valve is in the
correct position.
• Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
E1 is displayed on
LED Screen
• Unplug unit and allow to sit for 20 minutes. If no
change, Please call Breville Consumer Support.
E2 is displayed on
LED Screen
• Ensure the cooking bowl is properly positioned
inside base. The cooking bowl must be in direct
contact with the heating plate. Make sure there are
no unwanted materials on the heating plate.
E3 is displayed on
LED Screen, Beeping
• SAUTE/SEAR setting will not work if the lid is on or
locked in position. Ensure the lid is off or placed on
top of the appliance in an offset position.
The appliance automatically
switches to Keep Warm
without going through a
complete cooking cycle
• Add more water to cooking bowl and restart the
cooking cycle.
Air is escaping from the rim
of the lid
• Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
• Check that lid is closed properly.
Steam is released from
the safety locking pin
during cooking
• Inspect the safety locking pin (see page 9, letter "U").
The pin should move up and down freely, and have
a silicone seal on one end. Clean the pin and replace
the seal if necessary.
• Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
Loading ...
Loading ...
Loading ...