Loading ...
Loading ...
Loading ...
32 49-85246-1
WARNING
SHOCK OR BURN HAZARD:
Before replacing oven light bulb, disconnect the
electrical power to the range at the main fuse
or circuit breaker panel. Failure to do so may
result in electric shock or burn.
CAUTION
BURN HAZARD: The glass
cover and bulb should be removed when cool.
Touching hot glass with bare hands or a damp
cloth can cause burns.
Each oven is equipped with halogen light
columns located on the side walls of the oven.
The lights come on when the door is opened
or when the oven is in a cooking cycle.
Each light assembly consists of a removable
light cover with two locking clips and a light
compartment with three halogen bulbs.
Be sure to let the light cover and bulb cool
completely. For your safety, do not touch a hot
bulb with bare hands or a damp cloth.
To remove:
1. Remove the racks from the oven. See the
Full extension oven racks section.
8VLQJDƎQXWGULYHUUHPRYHWKHIRXUQXWV
holding the rack supports to the oven wall.
3. Remove the glass light cover by pulling its
back edge out and rolling it toward you. Do
not remove any screws.
4. Using gloves or a dry cloth, remove the
burned-out light bulb by pulling it straight out.
To replace:
Use a new 120-volt Halogen
bulb, with G8 pins, not to
exceed 25 watts.
Replacement bulbs may be purchased by
calling 800.626.2002. Order Part Number
WB25T10064.
NOTE: Higher wattage bulbs will damage your
oven.
Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb with
bare fingers. Oil from bare fingers may cause
hot spots on the glass surface and lead to
premature failure of the bulb. If you do touch the
glass, clean it with alcohol prior to installation.
1. Push the bulb straight into the receptacle all
the way.
2. Replace the light cover, by placing its front
edge under the front two tabs in the light
compartment. Roll the back edge into place,
making sure that it is firmly seated.
NOTE: If the locking clips fell from the glass
lens cover, hold them on the cover, in the
correct position, while replacing the cover
on the light compartment.
The light cover must be in place when
using the oven.
3. Reinstall the rack support. Be sure to orient
the support so that the top tabs for the nuts
are closest to the top of the oven. Lightly
secure with the four nuts removed earlier,
but do not over-tighten or the enamel could
be chipped.
4. Replace the racks. See the Full extension
oven racks section.
5. Reconnect electrical power to the oven.
Care and Cleaning
Professional All-Gas Range
Oven lights
Press the light cover into place
Place front
edge of lens
cover under
front two tabs
Locking
clips
Loading ...
Loading ...
Loading ...