Loading ...
Loading ...
Loading ...
8
245
In the event of a breakdown
F Switch on the ignition.
If a pressure of 2 bars is not reached after
about 7 minutes, this indicates that the
tyre is not repairable; contact a PEUGEOT
dealer or a qualified workshop for
assistance.
F Remove the kit.
F Remove and then store the bottle of sealant.
Take care, the sealant product is harmful
if swallowed and causes irritation to the
eyes.
Keep this product out of the reach of
children.
The use-by date of the fluid is marked on
the bottle.
After use, do not discard the bottle in
standard waste, take it to a PEUGEOT
dealer or an authorised waste disposal
site.
Do not forget to obtain a new bottle of
sealant, available from a PEUGEOT
dealer or a qualified workshop.
Do not exceed the speed of 50 mph
(80 km/h) when driving with a tyre repaired
using this type of kit.
Checking/adjusting tyre
pressures
You can also use the compressor,
without injecting sealant, to check and, if
necessary, adjust the tyre pressures.
F Remove the valve cap from the tyre and
keep it in a clean place.
F Uncoil the pipe stowed under the
compressor.
F Start the compressor by turning the switch
to position "l" until the pressure of the tyre
reaches 2.0 bars. The sealant product is
injected under pressure into the tyre; do not
disconnect the pipe of the valve during this
operation (risk of blowback).
F Place the switch in the "O" position.
F Disconnect the compressor's electric plug
from the vehicle's 12 V socket.
F Refit the cap on the valve.
F
Drive immediately for approximately three miles
(five kilometres), at reduced speed (between 12 and
37 mph (20 and 60 km/h)), to plug the puncture.
F
Stop to check the repair and measure the tyre
pressure using the kit.
F Screw the pipe onto the valve and tighten
firmly.
Loading ...
Loading ...
Loading ...