Loading ...
Loading ...
Loading ...
1
Rear fenders
On the rear fenders, it is recommended that you
install the antenna on the side of the vehicle
closest to the center of the road.
Use Technical Specification ISO/TS 21609 (Road
Vehicles – "EMCs for installation of aftermarket
radio frequency tr ansmitting equipment") when
retrofitting two-way radios. Comply with the
legal requirements for detachable parts.
If your vehicle has installing for two-way radio
equipment, use the power supply and antenna
connectors provided in the pre-installation.
Observe the manufacturer's supplements when
installing.
Two-way radio transmission output
The maximum transmission output (PEAK) at the
base of the antenna must not exceed the values
in the following table:
Frequency band and maximum transmission
output
Frequency band Maximum transmis‐
sion output
Short wave
3 - 54 MHz
100 W
4 m waveband
74 - 78 MHz
30 W
Frequency band Maximum transmis‐
sion output
2 m waveband
144 - 174 MHz
50 W
Trunked radio sys‐
tem/Tetra
380 - 460 MHz
10 W
70 cm waveband
400 - 460 MHz
35 W
Two-way radio
(2G/3G/4G)
10 W
The following can be used in the vehicle without
restrictions:
R
RF transmitters with a maximum transmis‐
sion output of up to 100 mW
R
RF transmitters with transmitter frequencies
in the 380 - 410 MHz waveband and a maxi‐
mum transmission output of up to 2 W
(trunked radio system/Tetra)
R
Mobile phones (2G/3G/4G)
Technical data
407
Loading ...
Loading ...
Loading ...